How to Increase Resin Heat on an Evolis Zenius 1 or Primacy 1

Increasing Resin Heat

• Open the Evolis Print Center, Double Click on the Zenius/Primacy printer.
• Click on Printing Tab.
• Click on Front side graphical setting to change the setting for the FRONT side of the card or Back side graphical settings for the BACK side.
• Use the slider bar to increase the Monochrome resin adjustment (heat) by steps of 2.
• Test printing.

With this adjustment, you should see better results. However, if unsatisfied, you can slow down the printing speed depending on your design, printer location, software, the font used, room temperature, and environment.

Slowing Monochrome Printing Speed

• Open the Evolis Print Center, Double Click on the Evolis Zenius 1 or Evolis Primacy 1 printer.
• Click on Printing Tab.
• Click on Advanced parameters.
• Use the slider bar to decrease the Monochrome printing speed by steps of 2.
• Test printing.

• Evolis - Zenius 1 Firmware and Driver
• Evolis - Primacy 1 Firmware and Driver

Tagged on: evolis, resin, k panel, heat, primacy 1, zenius 1